1. Before installation, carefully check the various standards of the Shinestar stainless steel elbow, whether the diameter meets the use requirements, eliminate the defects caused by the transportation process, and eliminate the dirt of the Shinestar stainless steel elbow, make preparations before installation, and be ready.
2. When installing, the Shinestar stainless steel elbow can be directly installed on the pipeline according to the connection method, and the installation is carried out according to the used position. Under normal circumstances, it can be installed at any position in the pipeline, but it requires easy-to-operate maintenance. Note that the medium flow direction of the cut-off Shinestar stainless steel elbow should be under the vertical valve disc, and the Shinestar stainless steel elbow can only be installed horizontally.
3. Pay attention to the tightness of the Shinestar stainless steel elbow during installation to prevent leakage and affect the normal operation of the pipeline. The bolts of theShinestar stainless steel elbow valve packing gland should be tightened evenly and should not be pressed into a crooked state, so as to avoid bruising, hindering the movement of the valve stem, or causing leakage.
4. When using Shinestar stainless steel elbow ball valves, globe valves, and gate valves, they are only used for fully open or fully closed, and are not allowed to adjust the flow rate, so as to avoid erosion of the sealing surface and accelerated wear. There is an inverted sealing device in the gate valve and the upper threaded stop valve, and the handwheel is turned to the upper position and tightened to prevent the medium from leaking from the packing.
5. The Shinestar stainless steel elbow should use a handwheel. Do not use levers or other tools to avoid damage to the valve. Turn the handwheel clockwise to close, and vice versa to open.
Post time: May-28-2021